Installing Tool Holder; Wet/Dry Vac Assembly; Insert Hose And Accessory Assembly - RIDGID RV2400A Owner's Manual

SP6636 1/10/07 9:52 AM

Installing Tool Holder

1. Install tool holder as shown with
extension wand holders facing unit.
Tote Snaps

Wet/Dry Vac Assembly

1. Position the powerhead assembly on
the drum/caddy assembly as shown
(assembled earlier).
2. Rotate both latches down and press
until you hear them snap over the
flanges on the drum.
Drum
Latch
Powerhead
Assembly
Latch
Drum
Page 11
2. As an alternative storage solution, the
tool holder may hang on a wall. Two wall
mounting hooks (not provided) must be
secured to the wall as shown (sold
Tote
separately).
Straps (4)
Handle
Extension
Wand
Storage
Locations
Insert Hose
Insert the push button end of the "Tug-A-
Long" hose into the inlet of the vac. The
hose should snap into place. To remove
the hose from the vac, press the release
button in the hose assembly and pull the
hose out of the vac inlet, as shown.
On the RV2600B, press the curved metal
extension wand into the coupling ring of
Drum the hose end.
Latch
Join the two metal extension wands,
aligning the button and hole so they snap
together.
Attach the accessories, aligning the button
Drum
and hole so they snap together.
Flange
Metal
Extension
Wand
(Curved)
Metal
Extension
Wand
(Straight)
Accessory
11
Grommet
Wall Mount
Hook
Wall
Coupling
Ring
Press Release
and Button
Pull
Wet/Dry Vac &
Hose Assembly