Wet/Dry Vac Assembly; Installing Tool Holder; Insert Hose - RIDGID RV24000 Owner's Manual

SP6729-1 RIDGID ESF_SP6636 2/12/13 8:32 AM Page 11
Drum/Caddy Assembly (cont.)

Installing Tool Holder

1. Install tool holder as shown with
extension wand holders (not included
on all models) facing unit.
Tote Snaps

Wet/Dry Vac Assembly

1. Position the powerhead assembly on
the drum/caddy assembly as shown
(assembled earlier).
2. Rotate both latches down and press
until you hear them snap over the
flanges on the drum.
Drum
Latch
Powerhead
Assembly
Latch
Drum
2. As an alternative storage solution, the
tool holder may hang on a wall. Two
wall mounting hooks (not included with
all models) must be secured to the wall
as shown (sold separately).
Tote
Straps (4)
Handle
Extension
Wand
Storage
Locations
(Not Included
On All Models)

Insert Hose

Insert the push button end of the "Tug-A-
Long™" hose into the inlet of the Vac.
The hose should snap into place. To
remove the hose from the Vac, press the
release button in the hose assembly and
pull the hose out of the Vac inlet, as
shown.
On the RV26000, press the curved metal
Drum
extension wand into the coupling ring of
Latch
the hose end.
Join the two metal extension wands,
aligning the button and hole so they snap
together.
Drum
Attach the accessories, aligning the
Flange
button and hole so they snap together.
Metal
Extension
Wand
(Curved)
Metal
Extension
Wand
(Straight)
11
Grommet
Wall Mount
Hook
(Not Included
with All Models)
Coupling
Ring
Press Release
and Button
Pull
Wet/Dry Vac &
Hose Assembly
Accessory
Wall