Blowing Feature - RIDGID WD18510 Owner's Manual

SP6733-1 Ridgid WD1851 ES
Operation (continued)

Blowing Feature

Your Vac features a blowing port. It can
blow sawdust and other debris. Follow the
steps below to use your Vac as a blower.
!
WARNING: Always wear safety
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
using as a blower.
!
WARNING: To reduce the risk of
injury to bystanders, keep them
clear of blowing debris.
!
CAUTION: Wear a dust mask if
blowing creates dust which might
be inhaled.
!
CAUTION: To reduce the risk of
hearing damage, wear ear protectors
when using the Vac/Blower for
extended time or in a noisy area.
1. Locate blowing port of your Vac.
2. Insert the locking end of the tug-along
hose into the blowing port of the Vac.
The hose should snap into place.
To remove the hose from the Vac,
press the release button in the hose
assembly and pull the hose out of the
Vac inlet.
3. (Optional) Attach extension wand to
opposite end of hose, then place the
car nozzle on the wand.
4. Turn Vac on and you are ready to use
your Vac as a blower.
10/4/10 9:08 AM
Tug-A-Long
Hose
Extension
Wand
(Optional)
13
Page 13
Car Nozzle (Optional)
Blowing
Port
Swivel
End of
Hose