Resetting The Standard Product Default Settings: All Application Work Groups; Test Menu - Honeywell 2020 User Manual

The Menu Commands
each of the commands (indicated by an asterisk (*) on the programming pages).
Note: Scanning this bar code also causes both the image scanner and the base
to perform a reset and become unlinked. The image scanner must be
placed in its base to re-establish the link before any setup codes are
entered. Refer to
information.
Resetting the Standard Product Default Settings:
All Application Work Groups
The following bar code defaults all of the work groups to the factory settings.
The Menu Commands
settings for each of the commands (indicated by an asterisk (*) on the program-
ming pages).

Test Menu

When you scan the Test Menu On code, then scan a programming code in this
manual, the image scanner displays the content of a programming code. The
programming function will still occur, but in addition, the content of that pro-
gramming code is output to the terminal.
Note: This feature should not be used during normal image scanner operation.
On
11 - 4
starting on page 12-5
"Image Scanner Modes"
Standard Product Default Settings:
Current Application Group
Standard Product Default Settings:
All Application Groups
starting on page 12-5
list the factory default settings for
on page 3-5 for additional
list the standard product default
* Off