Honeywell 2020 User Manual page 62

To rename image scanners with sequential, numeric names, scan the bar
codes below. Scan the Reset code after each name change and wait for the
scanner to re-link to the base before scanning another bar code to rename the
next image scanner.
Alternatively, you may change the name with a bar code command if you cannot
send serial commands to the base. One way to do this is to scan the bar code
below and scan a number for the image scanner name. For example, if you had
7 image scanners to one base, scan the bar code below with the first image
scanner, scan the 1 bar code on the
of this manual and scan Save. Then scan the Reset bar code and wait for the
scanner to re-link to the base before scanning the next bar code. Repeat that
process for image scanner number 2, 3, 4, etc.
If you want to assign an alphabetic name to the image scanner, create a Code
128 bar code containing "~BT_NAM name ." followed by a FNC3 character (hexi-
decimal 83), where name is the new image scanner name. Scan the Reset bar
3 - 8
0001
0003
0005
0007
Image Scanner Name
Programming Chart
0002
0004
0006
Reset
inside the back cover