Showing The Connection Status - NETGEAR Wireless-N 150 User Manual

Wireless-N 150 ADSL2+ Modem Router DGN1000 User Manual
Table 4-2. Router Statistics Fields
Field
WAN, LAN, or WLAN
Up Time
ADSL Link Downstream
or Upstream
Connection Speed
Line Attenuation
Noise Margin
Poll Interval

Showing the Connection Status

In the Router Status screen, click the Connection Status button to display a screen similar to the
one in the following figure:
Figure 4-7
4-8
Description
The statistics for the WAN (Internet), LAN (local), and wireless LAN (WLAN)
ports. For each port, the screen displays the following:
• Status. The link status of the port.
• TxPkts. The number of packets transmitted since reset or manual clear.
• RxPkts. The number of packets received since reset or manual clear.
• Collisions. The number of collisions since reset or manual clear.
• Tx B/s. The current line utilization—percentage of current bandwidth used.
• Rx B/s. The average line utilization.
The time elapsed since the last power cycle or reset.
The statistics for the upstream and downstream ADSL link. These statistics will be
of interest to your technical support representative if you are having problems
obtaining or maintaining a connection.
Typically, the downstream speed is faster than the upstream speed.
The line attenuation increases the further you are physically located from your
ISP's facilities.
The signal-to-noise ratio and is a measure of the quality of the signal on the line.
The interval at which the statistics are updated in this window. Click Stop to
freeze the display.
v1.1, January 2010
Managing Your Network