NETGEAR Wireless-N 150 User Manual page 40

Note: Your wireless settings remain the same when you add another WPS-enabled client,
as long as the Keep Existing Wireless Settings checkbox is selected in the
Advanced WPS Settings screen. If you clear this checkbox, when you add the cli-
ent, a new SSID and passphrase will be generated, and all existing connected wire-
less clients will be disassociated and disconnected from the modem router.
To add a wireless client device that is WPS-enabled:
1. Follow the procedures in
Network and Security" on page
2. To view a list of all devices connected to your modem router (including wireless and Ethernet-
connected), see "Viewing Attached Devices" on page
For non-WPS clients, you cannot use the WPS setup procedures to add them to the wireless
network. You must record, and then manually enter your security settings (see
Configuring Your Wireless Security" on page
To connect a combination of non-WPS enabled and WPS-Enabled clients to the modem router:
1. Restore the modem router to its factory default settings (press both the Wireless and WPS
buttons on the side of the modem router for 5 seconds).
When the factory settings are restored, all existing wireless clients are disassociated and
disconnected from the modem router.
2. Configure the network names (SSIDs), select the WPA/PSK + WPA2/PSK radio button on the
Wireless Settings screen (see
and click Apply. On the WPA/PSK + WPA2/PSK screen, select a passphrase and click Apply.
Record this information to add additional clients.
3. For the non-WPS devices that you want to connect, open the networking utility and follow the
utility's instructions to enter the security settings that you selected in
PSK + WPA2/PSK security method, and passphrase).
4. For the WPS devices that you want to connect, follow the procedures in
Connect (WPS) to Configure Your Wireless Network and Security" on page
The settings that you configured in Step 2 are broadcast to the WPS devices so that they can
connect to the modem router.
Note: To make sure that your new wireless settings remain in effect, verify that the
Keep Existing Wireless Settings checkbox is selected in the Advanced WPS
Settings screen.
Configuring Your Wireless Network and Security Settings
Wireless-N 150 ADSL2+ Modem Router DGN1000 User Manual
"Using Push 'N' Connect (WPS) to Configure Your Wireless
2-13.
2-7).
"Manually Configuring Your Wireless Security" on page
v1.1, January 2010
4-9.
"Manually
step 2 (the SSID, WPA/
"Using Push 'N'
2-7)
2-13.
2-17