Device Processes Window - Cisco 6000 series Configuration Manual

Chapter 6 Administration
The Firmware window appears. If you change any options in this window, you must click the Save
Settings button to save the changes. If you do not click this button, changes are not retained when you
exit the window. Save Settings appears at the bottom of the window. You might need to scroll down to
it.
Table 6-4
Table 6-4
Option
Device Information Area
IP Address
MAC Address
Device Name
Firmware Maintenance Area
Firmware Version
Firmware Released
Date
Details button
Firmware Upgrade
Upgrade button

Device Processes Window

The Device Processes window displays the processes that occupy TCP or UDP ports, and lets you stop
any of these processes.
To stop any process, click the Delete button that appears to the right of the process in the window.
Note
Take care when stopping processes because some processes are required for the camera to operate
properly. Processes that you stop in this window can restart the next time that you log in to the IP camera.
If you delete a required process and the camera stops functioning, exit your web browser and then log
back in to the IP camera to restart the process. If the process does not restart, power the IP camera off
and then back on.
To display the Device Processes window, perform the following steps:
OL-28691-01
describes the options in the Firmware window.
Firmware Window Options
Description
Display only. IP address of the IP camera.
Display only. MAC address of the IP camera.
Display only. ID of the IP camera, as configured in the Basic window. For
more information, see the
Version of the firmware that is installed on the IP camera.
Release date of the current firmware.
Click this button to display a pop-up window with additional information
about the firmware on the IP camera.
To upgrade the firmware on the IP camera, begin by entering the path and
folder where new firmware file for the IP camera is stored. The upgrade file
may be stored on another PC. You can click Browse to find this location.
After entering the path and folder for the firmware file, click this button to
load the firmware upgrade on the IP camera.
Do not power down the IP camera during the upgrade procedure.
Cisco Video Surveillance 6000 Series IP Camera Configuration Guide, Release 1.1.2
Device Processes Window
"Basic Window" section on page 5-1.
6-7