Io Ports Window - Cisco 6000 series Configuration Manual

Event Notification Window
Table 4-6
Table 4-6
Option
Input Ports Area
Port #
Current State
Event Trigger
Output Ports
Port #
Current State
Default State
Event Action
Automatic Reset
Duration
Event Notification Window
The Event Notification window provides options for how the IP camera handles events. An event is any
of the following:
•
•
•
When an event occurs, it triggers the IP camera to take certain configured actions:
•
Cisco Video Surveillance 6000 Series IP Camera Configuration Guide, Release 1.1.2
4-10
describes the options in the IO Ports window.
IO Ports Window Options
Description
Display only. Indicates input port 1 and input port 2.
Display only. Indicates the current state (high or low) of the corresponding
port.
Choose the state (Rising or Falling) that triggers designated camera actions.
When an input port changes to the configured state, the camera determines
that an event has occurred and takes the actions that you have configured.
Display only. Indicates output port 1 and output port 2.
Display only. Indicates the current state (high or low) of the corresponding
port.
Choose the state (low or high) that the corresponding port is set to when the
IP camera powers on or resets.
The port changes to this state when you click Save Settings.
The default setting is High.
Display only. Indicates the current state (high or low) to which the output
port changes when an event occurs.
Check this check box if you want the corresponding output port to go back
to its default state after an event occurs.
If you checked the Automatic Reset check box, enter the amount of time, in
milliseconds, that elapses before the port goes back to its default state after
an event changes it from the default state.
A change of state from low to high or from high to low on an input port of the IP camera. For related
information about input ports, see the
Motion that the IP camera detects. For related information about motion detection, see the
detection controls" rows in
Loss of video signal.
HTTP notification—IP camera sends notification to a remote system via HTTP. This information
includes the following:
Device ID—ID of the IP camera.
–
"IO Ports Window" section on page
Table 3-1.
Chapter 4 Feature Setup
4-9.
"Motion
OL-28691-01