GE JG5P34 Use And Care & Installation Manual page 46

TO
HOW CONVERT THE RANGE FOR
WITH
5. To prevent leakage, make sure the orifice
spuds are securely screwed into the gas inlet
tubes. Use a small wrench to hold the inlet tube
hex to prevent it from twisting.
6. Put old orifice spuds back in the bag to save
for possible future conversion.
dropped, the cooktop
can be ra~sed by
the 2 front clips
with a large flat
blade screwdriver.
"engaging
DO NOT attempt to raise the cooktop without
removing all 4 burner bases.
If wires were disconnected to remove the
cooktop, feed wires through the burner holes in
the cooktop. Attach to each burner electrode
terminal carefully, making sure not to bend the
terminal. Then lower cooktop until it snaps
over the clips.
Tall Screw
7. Carefully insert burner bases straight down
with the tube over the otilce spud. Replace the
screws, making sure the ti~ screw is
opposite the burner electrode in each
burner base.
46
USE
(continued)
MODELS EQUIPPED WITH STANDARD TWIN
BURNERS (See Step 3 if range is equipped with
sealed burners.)
1. Lift cooktop.
2. Lift burner assemblies strai
aside to gain
access to surface
burner spuds.
3. With a 5/16"
or a small
adjustable
wrench, remove
each of the four
spuds on the
surface burner
gas inlet tubes
and replace them
with the correct gas spuds mounted in a holder
at the right rear of the range, above the
regulator. Natural gas spuds are brass and LP
gas spuds are red or silver. (Mount the spuds
that you removed born the inlet tubes back in
the holder.) To prevent leakage, make sure
spuds are securely screwed into gas inlet tubes.
Electrode
4. Replace the burner assemblies.
5. Keep all spuds with your range so you have
them if you move or get a different gas hook-up.
Top Burner Ofice Drill Ske
Natural Gas
CONVERTING SURFACE BURNERS ON
#54 (.0550 Dia.)
#66 (.0330 Dia.)
Color
Brass
Red or Silver