GE JG5P34 Use And Care & Installation Manual page 44

Xl44 self-cleaning gas range
Table of Contents

Advertisement

HOW TO CONVERT THE RANGE FOR USE
WITH 1P GAS OR NATURAL GAS
range leaves the factory set for use with
This
natural gas. H you convert to LP gas, keep these
instructions and orflces in case you want to
convert back to natural gas.
TOOLS REQUIRED:
T-10 Torxdriver (for sealed burners)
1/2" and 3/4" open-end wrench
Flat blade screwdriver (small)
Nut drivers or wrenches: 7mm, 5/16" or a small
adjustable (depending on the size of the spuds)
PREPARE RANGE FOR CONVERSION
(1) Turn off gas supply at the wall.
(2) Turn off the electrical power to the range.
If range has not yet been connected to gas supply,
or if flexible connection was made, range maybe
pulled out from the wall to make conversion easier.
CONVERT THE PRESSURE REGUUTOR
Do not remove the pressure
regulator from the range.
1. For models equipped with sealed burners,
remove the storage drawer, broiler drawer or
kick panel and locate the pressure regulator at
rear of the range.
Remove Screws
Access Cover
On some models, you may have to remove an
access cover also.
For models equipped with stindard twin
burners, remove the cooktop and locate the
pressure regulator at right rear of range.
2. Follow the directions in A or B that match
your regulator type.
44
(models with lift-up cooktop)
NAT
Cap
If it is this regulator:
1. Use a coin to remove the cap from the
pressure regulator.
2. Turn the cap over and hook it into the slots.
The type of gas to be used should now be visible
on the top of the cap.
(models without lift-up cooktop)
-ever shown closed
except
If it is this regulator:
1. Unscrew the plastic-protected hex-nut cap
from the regulator.
2.
the threaded metal cap. Gently pull the plastic
washer off the threads on the other side of the
metal cap.
3. Push the plastic cap onto the end of the metal
cap displaying the type of gas you are converting
to. Press the attached plastic washer onto the
threads on the other side of the metal cap.
n
4. Screw the hex-nut cap back into the regulator.
Do not overtighten.
Standard Twin Burner Models
Flow
Range
closed.
TO OPEN,
Sealed Burner Models
for conversion
Carefully pry the protective plastic cap off
Cap

Advertisement

Table of Contents
loading

This manual is also suitable for:

Jg5p38Jgbp26Jgbp35Jgbp31

Table of Contents