To Cancel The Timer; Display Messages; Power Outage - GE JG5P34 Use And Care & Installation Manual

Xl44 self-cleaning gas range
Table of Contents

Advertisement

OVEN CONTROL, CLOCK Am T~ER
Clock
The clock must be set for the automatic oven timing
functions to work properly. The time of day cannot
be changed during a Timed Baking or Self-Cleaning
cycle.
Timer
The timer is a minute timer;
it does not control oven operations.
The maximum setting on the timer
is
9
hours and 55 mi~utes.
To Reset the Timer
If "TIMER" is displayed, press the INCREASE or
DECREASE pad until desired time is reached.
If "TIMER" is not displayed, press the TIMER pad
first, then follow the instructions above to set the timer.
End of Cycle Tone
The end of cycle tone is a series of three beeps
followed by one beep every six seconds. If you would
like to remove the signal that beeps every six seconds,
press and hold the CLEAWOFF pad for 10 seconds.
To return the signal that beeps every six seconds,
press and hold the CLEAWOFF pad for 10 seconds.

Power Outage

After a power outage, when power is restored, the
display will flash and time shown will no longer be
correct-for example, after a 5-minute power
interruption the clock will be 5 minutes slow.
To Set the Clock
CLOCK
Press the INCREASE or DECREASE pad to set the
2.
time of day.
CLOCK
To Set the Timer
1.
Press the TIMER pad.
TIMER
n
2. Press the INCREASE
A
or DECREASE pad
to set the amount of
time on the timer.

To Cancel the Timer

Press and hold the TIMER pad until the word
"TIMER" disappears from the display.

Display Messages

If "door" appears in the display, the door is open.
Close the door. If "LOCK" appears in the display, the
oven door is in the locked position. BAKE, BROIL
and COOK TIME cannot be set if the door is in the
locked position.
All other functions that were in operation when the
power went out will have to be programmed again.
1. Press the CLOCK pad.
3.
Press the CLOCK pad to start.
The timer will start automatically
within a few seconds of releasing
the pad. The timer, as you are
setting it, will display seconds until
1 minute is reached. Then it will
display minutes and seconds until
60 minutes is reached.
After 60 minutes, it will display
hours ("HR" now appears in
display) and minutes until the
maximum time of 9 hours and
55 minutes is reached.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Jg5p38Jgbp26Jgbp35Jgbp31

Table of Contents