GE 164D2966P126 Use And Care Manual page 31

Quick Reminder:
1. Press the AUTO SELF CLEAN pad.
2. Press the INCREASE or DECREASE pad
until the desired Clean Time appears.
—
cycle, the word "OFF" wfil appear in the display.
to set the cycle.
NOTE: Only one oven at a time can be self-cleaned.
1. Follow the directions in the Before a Clean
Cycle section.
2. After closing the door, press the
(
AUTO SELF CLEAN pad.
AUTO SELF
CLEAN
3. Press the INCREASE or
DECREASE pad until the
desired Clean Time is displayed.
@ \
Clean Time is normally 3 hours.
You can change the Clean Time to
any time between 2 and 4 hours,
depending on the amount of soil
in your oven.
To Stop a Clean Cycle
1. Press the CLEAR/OFF pad.
CLEAR
OFF
The self-clean cycle will automatically begin after
"CLEAN" is displayed and the time for the clean
appear in the display when the door automatically
locks. It will not be possible to open the oven door
until the temperature drops below the lock
temperature and the LOCK light goes off.
4. When the LOCK light is off, open the door.
NOTE:
The word "clean" will be displayed, the word
"DOOR" will flash and oven control will signal
if you set the clean cycle and forget to close the
door.
oven
A fan may automatically turn on and off to cool
internal parts. This is normal and the fan may
continue to run even after the oven is turned off.
You can find out when the clean cycle
1
will be finished by pressing the STOP
STOP
TIME TIME pad.
2. When the LOCK light goes off and the oven
temperature has cooled below the locking
temperature, open the door.
31