Buffalo WBMR-HP-GN User Manual page 8

Back Panel
1
2
3
4
1. DSL Line
Connect your ADSL line to this port.
2. LAN Ports
The Ethernet ports are RJ45, 10/100 auto-negotiation. The ports are labelled 1
through 4. These ports correspond to the numbered LEDs on the front of the
Router. Connect your network-enabled computers or any networking devices
to one of these ports.
3. Security Selection Switch
This switch allows you to choose the required method to configure a wireless
connection, either WPS or AOSS. To initiate AOSS, you must also press the
AOSS button on the top of the device.
4. Power
Connect the included power cord to this inlet.
The "Reset" button is located on the bottom of the modem router and should
be used in rare cases when the Router may function improperly. Resetting
the Router will restore the Router's normal operation while maintaining the
programmed settings.
You can also restore the factory default settings by using the Reset button.
Use the restore option in instances where you may have forgotten your
custom password.
6