Table of Contents
Advertisement
Chapter 1
Overview
PTZ IP Camera Physical Details
Figure 1-1
Figure 1-1
Reset Button
Network LED
Status LED
Lens
Figure 1-2
OL-28954-01
and the table that follows describe the outer view of the PTZ IP camera.
Outer View of the PTZ IP Camera
This drawing shows a camera with its dome
cover removed.
Reset Button
Network LED
Status LED
Lens
Recessed button that reboots the PTZ IP camera or resets it to
a default state. You can use a pin or paper clip to depress it.
Depending on how long you depress the reset button, you can
do either of the following:
•
•
Status of the network to which the camera is attached.
Status of the PTZ IP camera. For more information, see
Table
Lens that pans, tilts and zooms.
and the table that follows describe the inner view of the PTZ IP camera.
Reset—Press and release the reset button. Wait for the
PTZ IP camera to reboot.
Restore—Press and hold the reset button for about 30
seconds. All settings are restored to the factory defaults.
1-1.
Cisco Video Surveillance PTZ IP Camera Installation Guide
PTZ IP Camera Physical Details
1-3
Advertisement
Table of Contents
