Connecting The Cables - Cisco PTZ Installation Manual

Chapter 2 Installing the Camera
Push the seal (B) into the housing (D).
Step 5
Insert the seals (C) into unused holes on the seal (B) to avoid moisture.
Step 6
Secure the sealing nut (E) and hex nut from the bottom of the camera tightly.
Step 7

Connecting the Cables

Perform the following steps to install and connect the I/O wires and RJ45 Ethernet cable.
Avoid touching the circuit boards to prevent damage by electrostatic discharge.
Caution
We recommend using 24AWG (0.51 mm) gauge cable.
Note
Use a small-size flat-blade screwdriver to secure I/O wires to the included terminal blocks.
Step 1
Drill a hole on the rubber seal plug and insert an Ethernet cable (without a connector) through the
Step 2
opening.
Strip about 1/2 inch (12 mm) of the sheath from the Ethernet cable.
Step 3
Use an RJ45 crimping tool to attach the Ethernet wires to a connector. When done, connect the cable to
Step 4
the camera's Ethernet RJ45 socket.
OL-28954-01
Cisco Video Surveillance PTZ IP Camera Installation Guide
Installing the PTZ IP Camera
2-5