Connecting To The Network - Cisco PTZ Installation Manual

Connecting to the Network

Connecting to the Network
Use the following steps to connect the camera to a Power over Ethernet (PoE) switch:
Step 1 Connect the camera's Ethernet cable (CAT5e or better) to a PoE Plus switch.
Connect the power wires to an AC 24V power adaptor (user-supplied).
Step 2
If you are using a non-PoE switch, use a high power PoE power injector with a 60W output to connect
between the camera and non-PoE switch.
What to do next
•
•
Cisco Video Surveillance PTZ IP Camera Installation Guide
2-12
A30W PoE output port alone cannot drive the onboard heater. If using the PoE switch, the
application does not apply in low-temperature condition. A 30W PoE plus can only drive the camera
when it is working at a temperature higher than -10ºC.
The AC 24V adapter can drive the camera and the onboard heater. You can connect both power
sources for redundancy in power supply.
Sufficient power is required for low temperature conditions when the onboard heater is activated.
After you install the PTZ IP camera, follow the instructions in the
the IP Camera" section on page 3-1
After completing the initial setup, use the PTZ IP camera user interface in the Managing the Camera
section to adjust the focal length and zoom factor.
For complete configuration information, refer to the Cisco Video Surveillance PTZ IP Configuration
Guide.
IEEE 802.3at PoE Switch (30W output)
and / or
AC 24V 3.5A Adapter
(User-supplied)
High Power PoE Power
Injector
Non-PoE Switch
to access the camera through your network.
Chapter 2 Installing the Camera
"Performing the Initial Setup of
OL-28954-01