Mounting The Ptz Camera - Cisco PTZ Installation Manual

Installing the PTZ IP Camera
1
2
1
2
3

Mounting the PTZ Camera

Note Before mounting the camera, install an SD, SDHC, or SDXC card if you prefer recording to local
storage.
Step 1 Select a rigid mounting location to prevent vibration to the camera, and attach the alignment sticker to
the wall.
Note
Step 2 Drill four pilot holes (10mm in diameter and 4cm deep) into the wall, and hammer in threaded anchors.
Note
Step 3 Secure the wall mount bracket to wall using four sets of captive washers and nuts.
Step 4 Align the camera body with the top section.
a.
b.
Rotate the camera clockwise until its alignment mark is aligned with the "C" mark.
Step 5
Use the included T25 stardriver to securely tighten the three anti-tamper screws from the top.
Step 6
Cisco Video Surveillance PTZ IP Camera Installation Guide
2-8
3
Mount bracket
Interface section
Board-to-board connector
The camera weighs 3.66kg.
Hammer the anchors with hex nuts on them, so the threaded poles do not get deformed. If
preferred, drill another hole for routing cables.
Align the alignment mark on the camera with that on the interface section.
Push the camera up to match the top section.
Chapter 2 Installing the Camera
OL-28954-01