Configuring As A Stand-Alone Max3 - Honeywell Galaxy 3-48C Installation Manual

Configuring MAX
Configuring as a Stand-Alone MAX
1. Ensure that the MAX
(option 63.2.1 = OPTIONS.MAX.MAX Mode).
2. Select option 63.2.2 = OPTIONS.MAX.MAX Address and press the ent key; the Galaxy
searches for the MAX
(depending on model) for the AB line (1 – 4) that is to be searched; select the line and press the ent key.
On locating the MAX address, the keypad prompts for the
select 1 = Standalone and press the ent key. The MAX
When the reprogramming is complete the MAX
display returns to 2 = MAX Address.
3. Disconnect the AB line from the MAX
3
MAX readers) are still daisy-chained into the Galaxy panel. If the MAX
AB line, remove the 680Ω end of line resistor and put it into the last module on the line.
3
4. The MAX reader is now programmed as a stand-alone module in sleep mode (LEDs 3–7 on) and can
be programmed using the MAX
(cont'd)
3
3
is connected to the Galaxy (RS485 AB line) and the MAX mode is enabled
3
with the highest address (the new MAX
3
reader. Ensure that all other modules (keypads, RIOs and on-line
3
cards (refer to Programming Stand-Alone MAX
x
P
3
MAX
Figure 5-3. MAX
Galaxy 3 Series Installation Manual
3
3
reader). The Galaxy panel may prompt
OPERATING MODE
3
reader is readdressed as 32.
3
bleeps, LED 3-7 on the MAX
1 = Read (Amber)
2 = Open (Green)
3 = Closed (Red)
4 = Nightlock (Red)
5 = Add (Red)
6 = Void (Red)
7 = Program (Red)
3
LED's
5-4
of MAX to be assigned:
3
switches on and the keypad
3
reader is the last module on the
3
Readers).