Error Messages - Dell 1600n - Multifunction Laser Printer B/W Service Manual

6.9 Error Messages

The display on the front panel shows the messages to indicate the printer's status or errors. Refer to the tables below to
understand the message's meaning and clear the problem if necessary. The messages and their meanings are listed in
alphabetical order, with numbered messages following.
[Manual F. Jam]
Meaning: A paper jam has occurred in the manual feeder or the multi-function printer detects improper feeding from
the manual feeder.
Solution: Clear the paper jam. Load paper in the manual feeder correctly.
Cancel ? 1. Yes 2. No
Meaning: Your printer's memory is full and cannot store the document to send a fax into its memory.
Solution: To cancel the fax job, press the 1 button to accept "Yes."
If you want to send the pages that were stored, press the 2 button to accept "No." You should send the
remaining pages later when memory is available.
[COMM. Error]
Meaning: The multi-function printer has a communication problem.
Solution: Ask the sender to try again.
CRU Fuse Error [Low Heat Error]
Meaning: There is a problem in the fuser unit.
Solution: Check thermostat, thermister contact point & Heating Lamp.
CRU Fuse Error [Over Heat]
Meaning: The printer has overheated.
Solution: Your unit will automatically return to the standby mode when it cools down to normal operating temperature.
If failure persists,check the ELA HOU-FUSER.
Delayed Function
Meaning: The delayed fax jobs are full.
Solution: Cancel the unnecessary delayed fax job.
Document Jam
Meaning: The loaded document has jammed in the Automatic Document Feeder (ADF).
Solution: Clear the document jam.
[Door Open]
Meaning: The front or rear cover is not securely latched.
Solution: Close the cover until it locks into place.
Enter Again
Meaning: You entered an unavailable item.
Solution: Enter the correct item again.
Function Not Available
Meaning: You have tried to use a combination of printer functions that can not be used at the same time.
Solution: Reduce the number of selected functions or use only one function at a time.
Group No. is assigned
Meaning: The group dial location you tried to select has speed dial numbers assigned to it.
Solution: Press <Return>to start over with another group dial location.
Service Manual