Dell 1600n - Multifunction Laser Printer B/W Service Manual page 66

5.19 Pick-Up Ass'y & Solenoid
1. Before you remove the Pick-Up Ass'y, you should
remove:
- Rear Cover (see page 5-2)
- Side Cover (LH, RH) (see page 5-3)
- Front Cover (see page 5-4)
- Scanner Ass'y (see page 5-5)
- Middle Cover (see page 5-11)
- Engine Shield Ass,y (see page 5-13)
- Drive Ass'y (see page 5-18)
- Controller Shield Ass,y (see page 5-12)
- Feed Bracket (see page 5-21)
2. Remove the Pick-Up Gear Ass,y.
Pick up Gear
Ass'y
3. Take out the Pick-Up Ass'y, as shown below.
Bush
1
2
4. Remove the 2 s securing the Manual Solenoid and
Pick-Up Solenoid. Then remove Manual Solenoid and
Pick-Up Solenoid.
Pick Up
Solenoid
Manual
Solenoid
5. To replace the pick up roller, move the stopper secur-
ing the sponge-roller to the right and then turn the
sponge-roller to remove it from the shaft.
Sponge Roller
When replacing the pick up roller only, it is possible to
remove it by turning over the set after removing the
cassette and the processor.
Precautions
Stopper
Shaft
Service Manual
5-23