Dell 1600n - Multifunction Laser Printer B/W Service Manual page 155

1) Application Network:
2) Communication Mode:
3) Communication Standard:
4) Max. Modem Speed:
5) Encoding:
6) Transfer Rate:
7) Fax Modes:
8) Fax Contrast:
9) Fax Memory:
10) TX/RX Journal :
11) Tel/ID List:
12) Confirmation Reports for Send:
13) Management Reports:
14) TTI/RTI:
15) Line Control Unit (LIU):
16) Header Transmission (Always On):
3 PSTN (RJ-11)
Half-Duplex, ITU V.8, V.34, V.17, V.29, V.21, ECM
> Modem will auto train down only.
> .
ITU-T Group 3
33.6 Kbps
MH, MR, MMR, JPEG
3 seconds (standard resolution, MMR, 33.6kbps)
> Phase "C" by ITU-T No.1 Chart/Memory Transmission/ECM
Standard (203 x 98 dpi)
> Fine (203 x 196 dpi)
> Super Fine (300 x 300 dpi)
Adjustable 3 levels (Light/Normal/Dark)
4MB (About 300 Sheets of CCITT No.1 Chart at standard resolution).
User selectable parameters will be stored in NVRAM.
Available.
Available.
Upon successful transmission
> Upon failure
> Reduced image of first page (except OHD, and partial page for
complexity of the images)
> Customer On/Off selectable
> System Data List
> Image TCR for Memory TX
TTI (Transmit Terminal Identification) printed at top of Fax Image.
> RTI(Receiver Terminal Identification) printed at bottom of Fax
Image the Transmitting devices fax number is substituted for
receving devices fax number is this footer..
> Input Sensitivity: Not programmable
> Output Level: 9 to 15 db (programmable)
> Cable Equalization: Not programmable
> Input/Output Impedance: per PTT requirements (programmable)
> DC Resistance: per PTT requirements (programmable)
> Insulation Resistance: Minimum 5M ohm
Local Machine date and time
> Local Machine ID
> Local Machine Name
> Transmit page count (3 digits)
Circuit Diagram
Service Manual
11-7