Table of Contents
Advertisement
Power on
Using the SPF (AL-1622 only)
The SPF is designed to hold up to 30 originals.
G
Before loading originals into the SPF, be sure to remove any staples
or paper clips from them.
G
Damaged or crumpled originals may misfeed in the SPF. It is
recommended that these originals be copied from the original table.
G
Special originals such as transparency film and tracing paper should
not be fed from the SPF, but should be placed directly on the original
table.
G
Image loss (max. 4 mm) can occur at the leading and trailing edges of
the copies. Also image loss (max. 4 mm in total) can occur along the
other edges of the copies.
Turn the power switch on.
1
G
It will take about 35 seconds for the copier to warm up.
However, you can make desired settings and press the START key
during warm-up. Copying will start after warm-up.
G
If the copier has been programmed in the auditing mode, the START
key indicator will not light up and "––– " will appear in the copy
quantity display. Enter an assigned 3-digit account number. See page
16.
Ensure that no original is left on the original table.
2
Adjust the original guides to the size of the originals.
3
Set the originals face up in the document feeder tray.
4
G
The SPF indicator will light up. If this indicator does not light up, the
originals are not properly set or the SPF is not properly closed.
G
The ORIGINAL SIZE indicator for the detected original size will light
up. The paper tray with the corresponding paper size will be
automatically selected if that paper size is available and the auto paper
select function has been enabled.
G
The auto paper select function can be enabled or disabled using user
program No. 8. If this function has been disabled, use the TRAY
SELECT key to select the desired paper tray. See page 45, USER
PROGRAMS.
G
To copy onto a different size paper, use the TRAY SELECT key to
make the selection.
G
The bypass tray cannot be automatically selected.
Adjust the copy density.
5
G
This copier has three exposure modes to choose from — AUTOMATIC,
MANUAL, and PHOTO.
G
Automatic exposure is the standard initial setting for this copier. In this
mode, the characteristics of the original are "read" by the exposure
system and adjustments are automatically made. This optimizes the
contrast of the copied images by reducing the effect of coloured or
shaded background areas. See page 31 to adjust the automatic exposure
level.
NORMAL COPYING
19
Advertisement
Table of Contents
