Normal Shutdown; Emergency Shutdown - Husqvarna SG13 Operator's Manual

Normal Shutdown

Throttle
Set the throttle to SLOW/DISENGAGE.
If the engine has been running full out, let it run easily
for about 30 seconds to 1 minute at low speed.
DO NOT let front of unit touch ground until you are
sure cutting wheel has stopped turning.
Engine switch
Wait at least 20 seconds, until the blade has stopped.
Set the toggle switch to OFF.
Make sure that the blade is resting against the ground
and has stopped completely before doing anything.
Brake
Activate the brake by pulling the lever backwards.
Fuel valve
Close the fuel valve. Turn the lever all the way to the
left.

Emergency Shutdown

Release the OP grip bar. Wait until the blade stops.
Make sure that the blade is resting against the ground
and has stopped completely before continuing.
30
OPERATION
8064-011
8064-012
8060-024b