Set-Up - Husqvarna SG13 Operator's Manual

Attach the yoke to the brake's top mounting hole
using the clevis pin and cotter pin.
NOTE: Adjust the brake before inserting hair pin. To
engage brake, pull back on handle until brake rod
assembly goes "over center" and locks the brake
ON. Turning the yoke clockwise shortens the rod
tightening the grip on the brake disc by the brake
pads. Counter clockwise loosens the clamping force.
Brake adjustment is correct when wheel will slide but
not turn when handle is over center, and the wheel
turns freely when the brake handle is disengaged.
1. Remove air cleaner and double wire clamp from
engine.
2. Route the wire harness from engine and the throttle
cable through guide and handle crossmember.
3. Connect upper and lower wire harness together,
yellow to yellow—black to black.
4. Push throttle control lever on console forward to full
extent. Pull throttle control lever on engine back as
far as possible.
16

SET-UP

2
1. Clevis pin
2. Hair pin
1. Wire harness and throttle cable
2. Guide
1
1
8060-041
8060-042
2
8060-043