Operating On Hills; Transport - Husqvarna SG13 Operator's Manual

11. Before moving the machine forwards, you should
ensure that the cutting wheel is above the ground
and located on either side of the stump. Move
the machine forward by releasing the brake,
pushing it forward, activating the brake again and
repeating Steps 9 and 10.
12. Repeat Steps 9 through 11 until the upper portion
of the stump has been removed. DO NOT cut
deeper than ground level at this stage.
13. Set the throttle to SLOW/(START) DISENGAGE
and wait until the cutting wheel stops rotating.
14. Release the brake and pull the machine away
from the stump.
15. It may be necessary to clear wood chips from the
area around the stump.
16. If you want to grind below the ground level, it may
become necessary to adjust the handle position
to achieve a better hand and arm work position.
Pull the handle control lever and adjust the handle
to the desired position.
17. Repeat Steps 6 through 10 until you reach the
desired depth.
18. Shut off the machine when you are done.

Operating On Hills

Be very careful when operating the stump grinder
on hills because the machine can slip or move
unexpectedly.
NEVER use the machine on grades of 10° or steeper.

Transport

The Husqvarna stump grinder can be transported in a
truck, trailer, van or a large SUV (Sport Utility Vehicle).
The stump grinder is equipped with four lifting
handles (two on each side) so that two people can lift
the machine if necessary.
DO NOT attempt to lift the machine alone. Use safe
lifting techniques and DO NOT exceed your physical
limitations.
Secure the machine with tensioning belts, chains or
other approved materials.
OPERATION
The lifting handles can also be used to secure the machine
for transport.
8064-013
8064-014
8064-014
29