Speed Control Lever; Starter; Starter Handle - Husqvarna SG13 Operator's Manual

Speed Control Lever

The speed control lever on the engine is normally not
used. It is connected to the throttle on the handle. If
the cable should bind or break, you can reduce the
throttle with the lever on the engine as an emergency
measure to slow the engine speed to an idle and stop
the cutting wheel.

Starter

The magnapull-type starter has spring return. To
replace the return spring or starter cord, contact an
authorized service workshop.
IMPORTANT INFORMATION
Do not let the recoil cord snap back by itself.
This may damage the cord or the recoil
starter assembly.

Starter Handle

Misuse of the starter handle can damage the starter.
Do not twist the starter cord around your hand.
Pull out the handle slowly until the gears mesh. Do not
pull out the starter cord completely and do not let go
of the starter handle when extended.
WARNING!
Do not run the engine indoors, in
enclosed or poorly ventilated spaces.
Engine exhaust fumes contain
poisonous carbon monoxide.
CONTROLS
8011-034a
8011-127
19