Handle Engine Switch; Op Grip Bar; Starter Handle; Throttle - Husqvarna SG13 Operator's Manual

Handle Engine Switch

Set the toggle switch to ON.
Engine ON/OFF Switch
The switch on the engine is disconnected. Use the
Handle Engine Switch.

OP Grip Bar

Hold in the bar for the OP grip bar against the handle.

Starter Handle

The OP grip bar must be held against the handle
when starting the engine.
Misuse of the starter handle can damage the starter.
DO NOT twist the starter cord around your hand.
Pull out the handle slowly until the gears mesh. Then
give a sharp pull on the starter handle. DO NOT pull
out the starter cord completely and DO NOT let go of
the starter handle when extended. Return handle to
recoil position.

Throttle

Keep the throttle at idle. When the throttle is
increased, the cutting wheel will begin rotating.
26
OPERATION
8064-012
8060-029
8011-127