Grizzly g0602 Owner's Manual page 61

symptom possible Cause
Workpiece is 1. headstock and tailstock are not properly
tapered. aligned with each other.
Chuck jaws will 1. Chips lodged in the jaws or scroll plate.
not move or do not
move easily.
Carriage will not 1. Quick-change gears are not all engaged.
feed or is hard to 2. half nut lever engaged.
move. 3. Carriage lock is tightened down.
4. Chips have loaded up on bedways.
5. Bedways are dry and in need of lubrication.
6. gibs are too tight.
7. gears or shear pin broken.
Quick-change gear 1. gears not aligned inside headstock/quick
change dials will not change gearbox.
shift into position.
Model G0602/G0752 (Mfg. Since 11/12)
possible solution
1. re-align the tailstock to the headstock spindle
centerline (see page 34).
1. remove jaws, clean and lubricate scroll plate and
jaws, then replace jaws.
1. Adjust gear dials.
2. disengage half nut lever for manual feeding.
3. Check to make sure the carriage lock bolt is fully
released.
4. Frequently clean away chips that load up during
turning operations and re-lubricate.
5. lubricate bedways/ball oilers.
6. loosen gibs screw(s) slightly (see page 61).
7. replace gears or shear pin (see page 62).
1. rotate spindle by hand with light pressure on the
dial until gear falls into place.
-59-