Table of Contents
Advertisement
COMSPHERE 3900 Series Modems
Messages listed in Table 3-4 are common operational messages that occur during modem
operation. These messages normally appear on the second line of the LCD.
Common
Operational Message
Please Wait...
Command Sent...
No Rem Response or
Remote Modem Fail
Command Complete
Invalid Command
Messages listed in Table 3-5 are dial access security messages.
Dial Access Security
Message
Get VF PsWd
Get DTE PsWd
VF PsWd Timeout
Unknown DTEpswd
No Orig PsWd
Unknown VF PsWd
DTEpswd Timeout
Inval Orig PsWd
DTR Dial Blockd
SecurityBlocked
3-12
Table 3-4
Common Operational Messages
A command to a local device takes more than two seconds to complete.
A command is sent to a remote modem.
A remote modem does not respond to a command within 5 seconds.
A command, issued to a local or remote modem, is completed.
The modem cannot complete a command.
Table 3-5
Dial Access Security Messages
The answering modem is waiting for the originating caller to transmit a VF
password.
The answering modem is waiting to receive a valid DTE password from the
remote DTE.
The modem did not finish answering a call (disconnected) because the allowed
time limit was exceeded before the modem received a VF password from the
originating dialer.
The modem did not finish answering a call (disconnected) because the DTE
passwords received from the remote DTE were invalid.
The modem did not attempt to establish a call as requested because the AT dial
command did not contain an originate access password.
The modem did not finish answering a call (disconnected) because the modem
received an invalid VF password.
The modem did not finish answering a call (disconnected) because the allowed
time limit was exceeded before the modem received a DTE password from the
remote DTE.
The modem did not attempt to establish the call as requested because the
originate password in the AT dial command was not valid.
DTR dialing is not permitted when security is enabled. This message appears if
DTR dialing is used and Answer Access or Originate Access security is
enabled.
The access verification capabilities are not available and the modem does not
pass data to the DTE under any circumstances. This message appears only
when the modem is in base mode (a mode that occurs during a firmware
download) and Answer Access Security is enabled.
September 1998
Indicates
Indicates
3910-A2-GN32-40
Advertisement
Table of Contents
