Digicom COMSPHERE 3910 Installation And Operation Manual page 203

AT
Command
\Dn CTS Control.
\D0
\D1
\D2
\D3
\D4
\Gn Modem to Modem Flow Control.
\G0
\G1
\Kn Buffer Control, Send Break Control, Break Forces Escape.
\Nn Error Control Mode.
\N0
\N1
\N2
\N3
\N4
\N5
\N6
\N7
\Qn Flow Control of DTE, Flow Control of Modem.
3910-A2-GN32-40
Table 14-2
391x Series AT Commands
Description
Forced On. Forces CTS to always ON.
Standard RS232.
Wink When Disconnect. CTS is turned OFF for 1 to 2 seconds
upon a disconnect.
Follows DTR. The state of CTS follows the state of DTR.
Follows RTS. The state of CTS follows the state of RTS.
Disable.
Enable.
Break Buffer
Control:
\K0 Discard Data
\K1 Discard Data
\K2 Keep Data
\K3 Keep Data
\K4 Keep Data
\K5 Keep Data
Buffer Mode.
Direct Mode.
MNP or Disconnect.
MNP or Buffer.
V.42/MNP or Disconnect.
V.42/MNP or Buffer.
LAPM_or_Disc
LAPM_or_Bufr
Flow Control
of DTE:
\Q0 Disable
\Q1 XON/XOFF
\Q2 CTS to DTE
\Q3 CTS to DTE
\Q4 XON/XOFF
\Q5 Disable
\Q6 Disable
September 1998
(9 of 10)
Send Break Break Forces
Control: Escape:
Break First Enable
Break First Disable
Break First Enable
Break First Disable
Data First Enable
Data First Disable
Flow Control
of Modem:
Disable
XON/XOFF
Disable
RTS to Mdm
Disable
XON/XOFF
RTS to Mdm
AT Command Set and S-Registers
DCP LCD
Command
Sequence
Configure\Edit\
DTE Interface
Configure\Edit\
V42/MNP/Buffer
Break Buffer
Control:
Configure\Edit\
V42/MNP/
Send Break
Control:
Configure\Edit\
V42/MNP/Buffer
Break Forces
Escape:
Configure\Edit\
DTE Dialer
Configure\Edit\
V42/MNP/Buffer
Configure\Edit\
V42/MNP/Buffer
14-13