Table of Contents
Advertisement
Status
Call Disconnect
ATH Disconnect
Bad Lines Disc
No Carrier Disc
DTR
Disconnect
EC Disconnect
Inv Rate Disc
LnCurrnt Disc
LongSpace
Disc
NoData Disc
Disconnecting
RmtCmnded
Disc
Talk Mode
Firmware
DownldOnly
Download
Mode
Result
Frmware
Upgrade
RemClone
Failed
Firmware
Remote Clone
Download
OK
Result
Cont.
Bcast Clone
Done
AT Command
Reset by AT
Reset
command
3910-A2-GN32-40
Top-Level Menu Status
Message
The modem has disconnected due to an ATH command.
The modem has disconnected because the lines do not support the
modulation and/or data rate selected.
The modem disconnects due to the loss of carrier signal from the
remote modem.
The modem has disconnected due to the loss of DTR from the DTE.
The modem has disconnected due to failure to negotiate Error
Control mode.
When using V.32bis modulation, the remote modem does not
support the data rate used by the local modem.
The modem has disconnected due to the loss of line current.
The modem has disconnected due to the detection of a long space.
The modem has disconnected due to a lack of transmitted and
received data.
The modem has begun the disconnect sequence.
The modem has disconnected due to a V.32 Cleardown received
from the remote modem.
The modem is in Talk mode.
A local download of firmware or a remote cloning of firmware has
failed. The modem is currently in a Download Only mode in which
only another download attempt is possible.
A local download of firmware or a remote cloning of firmware was
successful.
A remote cloning of firmware has failed. This message appears on
the local modem's LCD.
A remote cloning of firmware was successful. This message
appears on the local modem's LCD.
A broadcast cloning of firmware has completed. You must look
under the Control branch for cloning results. This message appears
on the local modem's LCD.
The modem has performed a reset in response to an ATZ
command.
September 1998
Table 3-3
(3 of 3)
Indicates
DCP Operation
3-11
Advertisement
Table of Contents
