Honeywell DCP301 User Manual page 63

Chapter 5. FUNCTIONS
RUN
HOLD
FAST
END
AUTO
MANUAL
5-12
In this mode, the program is running.
MV outputs are active in PID control or ON-OFF control, and events and time events are
active.
In the program operation mode, program operation progresses according to the elapsed
time.
However, note that progress of program operation stops in the same way as the HOLD
mode when the controller is in the G.Soak (Guarantee Soak) standby state.
In this mode, the program is held.
Progress of program operation stops. However, note that MV outputs are active in PID
control or ON-OFF control, and events and time events are active in the same way as in
the RUN mode. The HOLD mode is not available during constant-value operation.
In this mode, the program is fast-forwarded.
This mode is like the RUN mode except that progress of the program operation time is
speeded up.
The time scale is selected by the variable parameter F A S T setting.
MV outputs are active in PID control or ON-OFF control, and events and time events are
active.
The controller does not enter the G.Soak standby state even if G.Soak (Guarantee Soak)
is set. The FAST mode is not available during constant-value operation.
In this mode, operation of the program has ended.
MV outputs are active in PID control or ON-OFF control, and events and time events are
active with program operation stopped at the program end point.
The END mode is not available during constant-value operation.
In this mode, program operation is automatic.
MV output is active according to controller control.
(However, note that when programmer functions are selected on 5G output models, SP
output is active according to controller control.)
In this mode, program operation is manual.
MV output can be changed by
(However, note that when programmer functions are selected on 5G output models, SP
output can be changed by
, , , on the console or communications.
, , , on the console or communications.)