Honeywell DCP301 User Manual page 58

• If the ON time is set to 0 in the case of G.Soak
standby, output becomes ON from the G.Soak
standby state, and the ON time is started at
completion of the G.Soak standby time.
The output time = G.Soak time + OFF time
(See segment 8 in the figure.)
• ON and OFF time settings the same time as
the segment end point are valid in the case of
the final segment END mode.
(See segment 10 in the figure.)
Segment No. events
The current segment No. is output as binary code.
When all of T1 to T5 are selected as segment No. events in the time event type setup, all
ON-OFF operations are as shown in the following table.
When T1 to T4 are assigned in part to segment No. events, only the assigned time events
operate as shown in the following table, and the remaining events operate as regular time
events.
Segment
No.
Event No.
T1
T2
T3
T4
T5
Segment
No.
Event No.
T1
T2
T3
T4
T5
Segment
ON time
OFF time
Output ON
Output OFF
Segment
ON time
OFF time
Output ON
Output OFF
Segment
ON time
OFF time
Output ON
Output OFF
1 2 3 4 5
ON OFF ON OFF ON OFF ON OFF ON OFF ON OFF ON OFF ON
OFF ON ON OFF OFF ON ON OFF OFF ON ON OFF OFF ON ON
OFF OFF OFF ON ON ON ON OFF OFF OFF OFF ON ON ON ON
OFF OFF OFF OFF OFF OFF OFF ON ON ON ON ON ON ON ON
OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF
16 17 18 19 20
OFF ON OFF ON OFF ON OFF ON OFF ON OFF ON OFF ON OFF
OFF OFF ON ON OFF OFF ON ON OFF OFF ON ON OFF OFF ON
OFF OFF OFF OFF ON ON ON ON OFF OFF OFF OFF ON ON ON
OFF OFF OFF OFF OFF OFF OFF OFF ON ON ON ON ON ON ON
ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON
G.Soak standby
When 0N = 0, output turns
ON when there is input to
segment 8.
ON = segment time
Segment time
ON = segment time
6 7 8 9 10
21 22 23 24 25
Chapter 5. FUNCTIONS
8
Segment 8 time start
9
10
END mode
11 12 13 14 15
26 27 28 29 30
5-7