Assembly & Setup; Handwheel; Hand Crank - Grizzly G4015Z Owner's Manual

SECTION 5: ASSEMBLY & SETUP
This section will cover the basics in assembly and
setup. We recommend you complete assembly in
the order in which it is presented to achieve the
best results.

Handwheel

The handwheel for the apron must be installed.
1. Remove the acorn nut and washer from the
cross feed Lead Screw.
Slide the handwheel onto the cross feed
2.
Lead Screw. Note the key way that is in the
bore of the handwheel and orient it so it
aligns with the key on the cross feed Lead
Screw.
3. Secure the handwheel with the acorn nut
and washer.
4. Secure the handle for the handwheel with a
screw driver as in Figure 4.
-12-
Do not connect the
machine to power at
this time. The machine
must remain unplugged
throughout the entire
assembly process.
Failure to do this may
result in serious per-
sonal injury.
Figure 4. Secure the handle with a screw driver.

Hand Crank

The hand crank for the longitudinal manual feed
must be installed.
1. The end of the Lead Screw has a small hole
that is cross-drilled near its end. The hand
crank has a similar hole drilled into the edge
of the center ball. Orient these holes to each
other and slide the hand crank onto the end
of the shaft.
2. Rotate the hand crank on the shaft until the
holes align.
Place the 4mm roll pin into the hole as in
3.
Figure 5 and drive it in with a hammer.
G4015 Lathe/Mill