dbx DriveRack 260 User Manual page 50

Section 5
Stored
Current
Stored
Current
42 DriveRack® User Manual
Utilities/Meters
• If any ZCs are currently connected and their dip switches properly set, the display will
read 'Panel Detected' for any such corresponding Panel (ID) numbers. Rotate the DATA
wheel to select the desired Panel (ID) number (options are 1-6). Once the panel to edit
has been selected, press the STORE button. The display will now give you the option of
selecting one of the following by rotating the DATA wheel:
ZC Setup
• ZC-1 (volume boost and cut)
• ZC-2 (volume boost and cut with mute) Panel 1
• ZC-3 (program change)
• ZC-4 (program change via contact closure)
(STORE) - EDIT PANEL
• If a ZC-1 or ZC-2 is selected, the display will appear something like this:
Panel 1
Boost 0dB Cut
ZC Setup
Output
Panel 1
(STORE) - EDIT PANEL
Pressing the DATA wheel will give you the option of setting the range of boost. Pressing
•
the DATA wheel again will now allow you to set the desired cut range (for full boost/
cut range, set boost to 10 and cut to 40; it is a good idea to then bring down your
Panel 1
crossover gains 10dB in order to make up for this 10dB boost). Once the boost and cut
Select A
Panel 1
range has been set, pressing and rotating the DATA wheel will let you select any of the
No Change
six outputs to be affected by the programmed level controller. Press the STORE button
Boost 0dB Cut
to get back to ZC Setup.
Output
• Selecting a ZC-3 gives the ability to assign switches A-D to call up any preset in the 260.
Once a ZC-3 has been selected, the display will appear something like this:
Panel 1
Switch
No Change
Panel 1
Select A
No Change
Pressing and then rotating the DATA wheel will allow you to first select the desired
•
position (A-D). These positions correspond to the rotary position labels on the ZC-3.
Panel 1
Once the desired position has been selected, press the DATA wheel again and rotate it
Switch
to select which program will be loaded when this selection (A-D) is made on the ZC-3.
No Change
Repeat this process for all other switch position/program assignments. Press the STORE
button to get back to ZC Setup
No change means that no program will be loaded for that selection.
• Selecting a ZC-4 gives the ability to load programs using SPDT type switches. Once a
ZC-4 has been selected, the display will appear something like this:
None
ZC-2
0dB
1 3 5
None
2 4 6
ZC-3
ZC-2
0dB
1 3 5
2 4 6
ZC-4
1 2 3 4
ZC-3
ZC-4
1 2 3 4
DriveRack
Set Security Level
Pre EQ
Low
Set Security Level
Pre EQ
Low
®