Navigating The Pre-Eq Section; Navigating The Crossover Section - dbx DriveRack 260 User Manual

DriveRack
Navigating the "EQ Section"
To edit the parameters of the EQs used in a selected program, simply use the following procedure. From program mode,
press the EQ button to reach the EQ module to be edited. Successive presses of the EQ button will move through each channel.
Navigate through the Pages of the selected EQ section by depressing "Next Page" or "Prev Page" successively until arriving at the desired Page.
EQ
The EQ button
toggles through
the EQs used in
EQ
each channel of
the selected
program
menu.
To edit the parameters of the Crossover used in a selected program, simply use the following procedure. From program mode,
press the X-OVER button. Once you have reached the Crossover module, Navigate through the Pages of the selected Crossover
module by pressing the "Next Page" or "Prev Page" buttons successively until arriving at the desired Page.
The XOVER button
toggles through
the XOVER used in
each channel of
the selected
program
menu.
®
2.3 Navigating the Pre-EQ Section (28-GEQ and PEQ)
GEQ Freq- 31.5Hz-18kHz
On/Off
GEQ
Flatten/Restore Gain -12dB to12dB
or
PEQ On/Off
PEQ
Flatten/Restore
Bell,HSelf, LShelf, LHShelf,
Successive presses of the Data wheel will select
effect parameters within the currently selected page.
Low Pass
XOVER
Freq- 19.7kHz to Out Freq- 20.kHz to Out
Slope - BS, BW, LR Slope - BS, BW, LR
(6,12,18,24,36,48) (6,12,18,24,36,48)
Successive presses of the Data wheel will select
effect parameters within the currently selected page.
Editing Functions
B1 Freq- 20Hz-20kHz B2 Freq- 20Hz-20kHz B2 Freq- 20Hz-20kHz
Gain -12dB to12dB Gain -12dB to12dB Gain -12dB to12dB
Q .20 to 16.0 Q .20 to 16.0 Q .20 to 16.0

2.4 Navigating the CROSSOVER Section

High Pass
Gain- -20 to 20dB
Repeat, for each crossover band
Section 2
GEQ/PEQ
...
XOVER
DriveRack® User Manual 15