Viewing Vlans Configured On The Nss - Cisco NSS2000 - Gigabit Storage System Chassis Administration Manual

Adding the NSS to your Network

Viewing VLANs Configured on the NSS

Viewing VLANs Configured on the NSS
STEP 1
STEP 2
Cisco Small Business NSS2000 Series Administration Guide
When you first display the Network VLAN page, the currently configured VLANs
appear. Configuring a VLAN to connect to the NSS depends if it is trunk-based or
port-based. To configure a trunk-based VLAN, follow the steps to allow a VLAN to
access the NSS; see
configure a port-based VLAN, configure the switch to assign the port to which the
NSS is connected to the desired VLAN. In this case, no NSS configuration changes
are required.
To view the VLANs currently configured on the NSS:
From the Manager Menu, click Network
The VLAN Configuration page appears.
View the following details for each existing VLAN that appears in the VLAN
Configuration table:
•
Link: The physical link attached to the NSS. The number appears as 1.
•
VLAN: The ID of the VLAN. This is configured when the VLAN is added to
the NSS and should match the ID of the VLAN as it is configured in your
network. The range of valid VLAN IDs is from 1 to 4095.
"Allowing a VLAN Access to the NSS" section on page
VLAN.
3
22. To
21