Configuring The Network Link Ip - Cisco NSS2000 - Gigabit Storage System Chassis Administration Manual

Adding the NSS to your Network

Configuring the Network Link IP

Configuring the Network Link IP
STEP 1
Cisco Small Business NSS2000 Series Administration Guide
•
Assign Via: The method used to assign an IP configuration to the physical or
virtual interface. Options include:
-
DHCP: The IP configuration was assigned by a DHCP server. Or, if the
interface was configured to use DHCP for IP configuration but no DHCP
server was found, the IP address was assigned by the AutoIP protocol.
-
Static: A static IP configuration was manually entered through the NSS
configuration interface.
•
IP Address: The IP address for the physical or virtual interface.
•
Netmask: The netmask for the physical or virtual interface.
•
Gateway: The address of the gateway for the physical or virtual interface.
You need to configure the method for assigning an IP configuration to each
interface connected to the NSS.
To set the IP address allocation method for an interface:
From the Manager Menu, click Network
The Network IP page appears listing each interface.
NOTE: If you hotplug the Ethernet link after
the initial installation of the NSS, make sure you
wait 15 seconds between the time you unplug
the cable and then plug it back in. The NSS
displays the correct new settings within 10
seconds.
IP.
3
18