HP Jetdirect 310x - Print Server For Fast Ethernet User Manual page 95

this IP administrative password.
IP host access list
Specifies up to 10 host systems, or networks of host
systems, that are allowed access to the print server and
the attached networked printing device.
Access is generally limited to host systems specified in
the list. However, if the list is empty, then all hosts are
allowed access. Also, host systems that use HTTP (via
the embedded web server
entries in the access list and are allowed access.
Configured on the print server using the
Security, Access Control
server (
Telnet, SNMP, or management software.
SNMP v1/v2c — Set Community Name
Acts as a password on the print server to allow incoming
SNMP Set commands (from management software, for
example) to write (set) configuration parameters on the
print server.
Authentication of SNMP Set commands will require that
they contain the user-assigned name.
Authentication of SNMP Set commands are further
restricted to systems identified on the
Configured on the print server using the
Network Settings, SNMP
server (
Telnet, the IP administrative password
synchronization), an
application services.
Telnet
Telnet is enabled by default, to allow configuration
changes to the print server using the
should disable Telnet access if relying on password
protection.
Configured on the print server using the
Network Settings, Other Settings, Misc.
server (
or IPP) are not checked against
menu
host access
menu
(with the optional
SNMP application, or management
Telnet
embedded web
item), TFTP,
list.
embedded web
item), TFTP,
tool. You
embedded web