HP Jetdirect 310x - Print Server For Fast Ethernet User Manual page 124

03
LAN ERROR-
EXTERNAL
LOOPBACK
07
LAN ERROR-
CONTROLLER
CHIP
08
LAN ERROR-
INFINITE
DEFERRAL
09
LAN ERROR-
BABBLE
0A
LAN ERROR-
NOSQE
0C
LAN ERROR-
RECEIVER OFF
0D
LAN ERROR-
TRANSMITTER
OFF
0E
LAN ERROR-
LOSS OF
CARRIER
10
LAN ERROR-
UNDERFLOW
11
LAN ERROR-
RETRY FAULTS
12
LAN ERROR- NO
LINKBEAT
The print server is incorrectly connected to your network or is defective.
Make sure your print server is correctly attached to your network. In
addition, check the cabling and connectors.
Check the network connections. If the connections are intact, run the
power-on self-test: turn the printer off, then on again. If the error
persists, replace the print server.
There is a network congestion problem.
Note: If the print server is not connected to the network, this error
cannot occur.
Check the network connections. If the connections are intact, run the
power-on self-test: turn the printer off, then on again. If the error
persists, replace the print server.
Check the network connections. If the connections are intact, run the
power-on self-test: turn the printer off, then on again. If the error
persists, replace the print server.
There may be a problem with your network cabling or the print server.
Check the cabling and connectors on your Ethernet network. If you
cannot find a problem with your network cabling, run the power-on
self-test: remove and re-attach the power module connector on the print
server. If the error persists, there is a problem with the print server.
There may be a problem with your network cabling or the print server.
Check the cabling and connectors on your Ethernet network. If you
cannot find a problem with your network cabling, run the power-on
self-test: remove and re-attach the power module connector on the print
server. If the error persists, there is a problem with the print server.
Check the network connections. If the connections are intact, run the
power-on self-test: remove and re-attach the power module connector
on the print server. If the error persists, replace the print server.
There may be a problem with your network cabling or the print server.
Check the cabling and connectors on your network. If you cannot find a
problem with your network cabling, run the power-on self-test: remove
and re-attach the power module connector on the print server. If the
error persists, there is a problem with the print server.
There is a problem with your network cabling or external network
configuration. Verify operation of the hub or switch port.
With a 10Base-T or 100Base-TX port connected, Link Beat is not
sensed. Check the network cable, and verify that the concentrator or hub
is providing Link Beat.