HP Jetdirect 310x - Print Server For Fast Ethernet User Manual page 74

Selects the method for the print server to receive its
IP configuration parameters: BOOTP (default), DHCP, or Manual.
BOOTP
IP
configured by a BOOTP or DHCP server each time the print server
Configuration
is powered on.
Method
Manual
web page, or using other available tools.
A Caution! Configuration tools.
Specifies a readable IP name (the SNMP SysName object) for the
network device. The name may contain up to 32 characters
Host Name
including numbers, upper- and lower-case letters, and hyphen and
underscore.
Use this field to manually assign the Internet Protocol address on
the print server. The IP address is a four byte (32-bit) address in the
form "n.n.n.n", where "n" is a number from 0 to 255. An IP address
IP Address
uniquely identifies a node on a TCP/IP network. Duplicate
IP addresses on a TCP/IP network are not allowed.
on IP
If subnetting is used, use this field to manually assign a subnet
mask. A subnet mask is a 32-bit number that, when applied to an
Subnet Mask IP address, determines which bits specify the network and subnet,
and which bits uniquely specify the node.
addressing.)
Default
Identifies the IP address of a router or computer that is used to
Gateway
connect to other networks or subnetworks.
Specifies the name of the Domain Name System (DNS) domain
Domain that the print server resides in (for example, "support.hp.com"). It
Name
does not include the host name; it is not the Fully Qualified
Domain Name (such as "printer1.support.hp.com").
Specifies the IP address of the primary Windows Internet Naming
Primary
Service (WINS) server. The WINS server provides IP address and
WINS Server
name resolution services for network computers and devices.
Secondary
Specifies the IP address to be used for WINS if the primary WINS
WINS Server
Server is unavailable.
Specifies the IP address of a host computer that is configured to
receive syslog messages from the print server. If a syslog server is
Syslog
not specified, syslog messages are disabled. See the
Server
description. See also the
Settings
Specifies the maximum number of syslog messages that can be sent
Syslog
by the print server on a per-minute basis. This setting allows
Maximum
administrators to control the log file size. The default is 10 per
Messages
minute. If set to zero, no maximum number is defined.
DHCP
or : the IP parameters will be automatically
: basic IP parameters can be manually entered using this
addressing.)
Syslog Facility
menu.
(See overview
(See overview on IP
syslog
Other
parameter in the