HP Jetdirect 310x - Print Server For Fast Ethernet User Manual page 130

46
INVALID SERVER
ADDRESS
47
INVALID TRAP
DEST ADDRESS
48
CF ERR- FILE
INCOMPLETE
49
CF ERR- LINE
TOO LONG
4A
CF ERR-
UNKNOWN
KEYWORD
4B
CF ERR-
MISSING
PARAMETER
4C
CF ERR-
INVALID
PARAMETER
4D
CF ERR- ACCESS
LIST EXCEEDED
4E
CF ERR - TRAP
LIST EXCEEDED
4F
TFTP REMOTE
ERROR
50
TFTP LOCAL
ERROR
51
TFTP RETRIES
EXCEEDED
52
BAD BOOTP/DHCP
REPLY
The TFTP server IP address specified for the print server (through
BOOTP) is an invalid IP address for specifying a single node. Check
your Bootptab file for proper entries.
One of the SNMP trap (Trap PDU) destination IP addresses specified
for the print server (through TFTP) is an invalid IP address for
specifying a single node. Check your TFTP configuration file.
The TFTP configuration file contained an incomplete last line that did
not end in a new line character.
A line being processed in the TFTP configuration file was longer than
the print server could accept.
A TFTP configuration file line contained an unknown keyword.
A line in the TFTP configuration file was missing a required parameter.
A line in the TFTP configuration file contained an invalid value for one
of the parameters on that line.
The TFTP configuration file specified too many access list entries using
the "allow:" keyword.
The TFTP configuration file specified too many trap destination list
entries using the "trap-destination:" keyword.
The TFTP transfer of the configuration file from the host to the print
server failed with the remote host sending a TFTP ERROR packet to the
print server.
The TFTP transfer of the configuration file from the host to the print
server failed with the local print server encountering some form of
inactivity timeout or excessive retransmissions situation.
The overall retrying of the TFTP transfer of the configuration file from
the host to the print server has exceeded a retry limit.
An error was detected in the BOOTP or DHCP reply that the print
server received. The reply either had insufficient data in the UDP
datagram to contain the minimum BOOTP/DHCP header of 236 bytes,
had an operation field that was not BOOTPREPLY(0X02), had a header
field that did not match the print servers hardware address, or had a
UDP source port that was not the BOOTP/DHCP server port (67/udp).