Upc-E1 - Honeywell 4800dr - Document Camera Barcode Manual

UPC-E0 Check Digit
Check Digit specifies whether the check digit should be transmitted at the end of the scanned data or
not. Default = On.
* On
UPC-E0 Number System
The numeric system digit of a U.P.C. symbol is normally transmitted at the beginning of the scanned
data, but the unit can be programmed so it will not transmit it. Default = On.
* On
UPC-E0 Addenda
This selection adds 2 or 5 digits to the end of all scanned UPC-E data. Default = Off for both 2 Digit and
5 Digit Addenda.
2 Digit Addenda On
5 Digit Addenda On

UPC-E1

Most U.P.C. barcodes lead with the 0 number system. For these codes, use
need to read codes that lead with the 1 number system, use the UPC-E1 On selection. Default = Off.
UPC-E1 On
6 - 18
Off
Off
* 2 Digit Addenda Off
* 5 Digit Addenda Off
UPC-E0 (page 6-17). If you
* UPC-E1 Off