Good Read Delay; User-Specified Good Read Delay; Trigger Modes; Manual/Serial Trigger - Honeywell 4800dr - Document Camera Barcode Manual

Good Read Delay

This sets the minimum amount of time before the document reader can read another barcode. Default =
No Delay.
* No Delay
Short Delay (500 ms)
Medium Delay (1,000 ms)
Long Delay (1,500 ms)

User-Specified Good Read Delay

If you want to set your own length for the good read delay, scan the barcode below, then set the delay
(from 0-30,000 milliseconds) by scanning digits from the inside back cover, then scanning Save.
User-Specified Good Read Delay

Trigger Modes

Manual/Serial Trigger

You can activate the document reader either by pressing the trigger, or using a serial trigger command
(see Trigger Commands on page 10-3). When in manual trigger mode, the document reader scans until
a barcode is read, or until the trigger is released.
When in serial mode, the document reader scans until a barcode has been read or until the deactivate
command is sent. In serial mode, the document reader can also be set to turn itself off after a specified
time has elapsed (see Read Time-Out, which follows).
* Manual/Serial Trigger
Read Time-Out
Use this selection to set a time-out (in milliseconds) of the document reader's trigger when using serial
commands to trigger the document reader, or if the document reader is in manual trigger mode. Once
the document reader has timed out, you can activate the document reader either by pressing the trigger
3 - 3