Honeywell 4800dr - Document Camera Barcode Manual page 31

Scan a barcode below to enable or disable Preferred Symbology.
Preferred Symbology On
High Priority Symbology
To specify the high priority symbology, scan the High Priority Symbology barcode below. On the
Symbology Chart on page A-1, find the symbology you want to set as high priority. Locate the Hex value
for that symbology and scan the 2 digit hex value from the Programming Chart (inside back cover). Scan
Save to save your selection. Default = None
Low Priority Symbology
To specify the low priority symbology, scan the Low Priority Symbology barcode below. On the
Symbology Chart on page A-1, find the symbology you want to set as low priority. Locate the Hex value
for that symbology and scan the 2 digit hex value from the Programming Chart (inside back cover).
If you want to set additional low priority symbologies, scan FF, then scan the 2 digit hex value from the
Programming Chart for the next symbology. You can program up to 5 low priority symbologies. Scan
Save to save your selection. Default = None
Preferred Symbology Time-out
Once you have enabled Preferred Symbology and entered the high and low priority symbologies, you
must set the time-out period. This is the period of time the document reader will search for a high priority
barcode after a low priority barcode has been encountered. Scan the barcode below, then set the delay
(from 100-3,000 milliseconds) by scanning digits from the inside back cover, then scanning Save.
Default = 500 ms.
Preferred Symbology Default
Scan the barcode below to set all Preferred Symbology entries to their default values.
High Priority Symbology
Low Priority Symbology
Preferred Symbology Time-out
Preferred Symbology Default
* Preferred Symbology Off
3 - 11