System Settings - Epson AcuLaser CX29NF User Manual
High- quality 4- in- 1
Hide thumbs
Also See for AcuLaser CX29NF:
- Setup manual (2 pages) ,
- Specifications (2 pages) ,
- Safety information manual (342 pages)
Table of Contents
Advertisement
Adobe Protocol
Purpose:
To set the PostScript communications protocol.
Values:
Auto
Standard
BCP
TBCP*
Binary
System Settings
Use System Settings to configure a variety of printer features.
Note:
Values marked by an asterisk (*) are the factory default menu settings.
Power Saver Timer
Purpose:
To specify the time for transition to power saver mode.
Values:
Low Power
3min*
Timer
3–60 min.
Sleep Timer
6min*
1–6 min.
Enter 5 to put the printer in power saver mode five minutes after it finishes a job. This uses much less
energy, but requires more warm-up time for the printer. Enter 5 if your printer shares an electrical
circuit with room lighting and you notice lights flickering.
Sets the PostScript communications protocol automatically.
Sets the PostScript communications protocol to Standard.
Sets the PostScript communications protocol to BCP.
Sets the PostScript communications protocol to TBCP.
Sets the PostScript communications protocol to Binary.
Specifies the time taken by the printer to enter Low Power mode after it finishes
a job.
Specifies the time taken by the printer to enter Sleep mode after it has entered
Low Power mode.
Using the Operator Panel Menus and Keypad
Epson AcuLaser CX29 Series
User's Guide
253
Advertisement
Table of Contents
Troubleshooting
