Chapter 2 Preparing For Installation; Safety Recommendations; Maintaining Safety With Electricity; Connecting The Interface Cables - Cisco ASA5500-HW - Hardware Accessory Kit Network Device Hardware Installation Manual

Safety Recommendations

Step 6 Follow the directions for establishing network connectivity in the
Verifying Connectivity" section on page
Safety Recommendations
Use the following guidelines and the information in the following sections to help ensure your safety and
protect the ASA. The list of guidelines may not address all potentially hazardous situations in your
working environment, so be alert and exercise good judgement at all times.
Note If you need to remove the chassis cover to install a hardware component, such as additional memory or
an interface card, doing so does not affect your Cisco warranty. Upgrading the ASA does not require any
special tools and does not create any radio frequency leaks.
Observe the following safety guidelines:
•
•
•
•
•
•
This section includes the following topics:
•
•
•

Maintaining Safety with Electricity

Before working on a chassis or working near power supplies, unplug the power cord on AC units;
Warning
disconnect the power at the circuit breaker on DC units. Statement 12
Follow these guidelines when working on equipment powered by electricity:
•
•
•
•
•
Cisco ASA 5500-X Series Hardware Installation Guide
2-2
Keep the chassis area clear and dust-free before, during, and after installation.
Keep tools away from walk areas in which you and others might fall over them.
Do not wear loose clothing or jewelry, such as earrings, bracelets, or chains that could get caught in
the chassis.
Wear safety glasses if you are working under any conditions that might be hazardous to your eyes.
Do not perform any action that creates a potential hazard to people or makes the equipment unsafe.
Never attempt to lift an object that is too heavy for one person to handle.
Maintaining Safety with Electricity, page 2-2
Preventing Electrostatic Discharge Damage, page 2-3
Working in an ESD Environment, page 2-3
Before beginning procedures that require access to the interior of the chassis, locate the emergency
power-off switch for the room in which you are working. Then, if an electrical accident occurs, you
can act quickly to turn off the power.
Do not work alone if potentially hazardous conditions exist anywhere in your work space.
Never assume that power is disconnected from a circuit; always check the circuit.
Look carefully for possible hazards in your work area, such as moist floors, ungrounded power
extension cables, frayed power cords, and missing safety grounds.
If an electrical accident occurs, proceed as follows:
"Connecting the Interface Cables and
3-2.
Chapter 2 Preparing for Installation