Configuring Wep - NETGEAR DGN2200M - Wireless-N 300 Router User Manual

Table 5. Wireless Settings (Continued)
Settings
Security Options None
WEP
WPA-PSK (TKIP)
WPA2-PSK (AES)
WPA-PSK (TKIP) +
WPA2-PSK (AES)

Configuring WEP

Note: If you use a wireless computer to configure wireless security
settings, you will be disconnected when you click Apply.
Reconfigure your wireless computer to match the new settings, or
access the wireless modem router from a wired computer to make
further changes.
To configure WEP data encryption:
1. Log in to the wireless modem router as described in
Modem Router
2. From the main menu, select Wireless Settings to display the Wireless Settings screen.
3. In the Security Options section, select the WEPradio button:
32 | Chapter 2. Wireless Network Configuration
N300 Wireless ADSL2+ Modem Router DGN2200M Mobile Edition User Manual
Description
You can use this setting to establish wireless connectivity before
implementing wireless security. NETGEAR strongly recommends that
you implement wireless security.
Use encryption keys and data encryption for data security. You can
select 64-bit or 128-bit encryption. See
Allow only computers configured with WPA to connect to the wireless
modem router. See
page 34.
Allow only computers configured with WPA2 to connect to the wireless
modem router. See
page 34.
Allow computers configured with either WPA-PSK or WPA2-PSK
security to connect to the wireless modem router. See
WPA, WPA2, or WPA + WPA2
on page 17.
Configuring WEP
Configuring WPA, WPA2, or WPA + WPA2
Configuring WPA, WPA2, or WPA + WPA2
on page 34.
Logging In to Your Wireless-N
on page 32.
on
on
Configuring