Remove Programs; Screen - Honeywell 7900L0P-422C20E - Hand Held Products Dolphin 7900 User Manual

The terminal is loaded with a number of pre-programmed regional settings. Select one from the list and the results appear on the

screen.

To see specific settings or change a specific setting, tap on one of the tabs, make the change and tap OK to save it.

Remove Programs

The Remove Programs settings enables you to remove programs installed on the terminal. Use this setting to troubleshoot when
you receive messages that the device is out of memory. The programs removed are removed from RAM memory. Any program
(usually *.cab or *.dll files) stored in the Autoinstall folder (My Device > IPSM > Autoinstall) will re-install after the next hard reset.
For information about the Autoinstall process, see Let Autoinstall Run on page 2-7.
For information about the hard reset process, see Hard Reset (Cold Boot) on page 2-11.
1. Tap Remove Programs. In the list, select the program you want to remove.
2. Tap Remove. The following message appears:
3. Tap Yes. Wait while the program is removed.
4. Verify that the program no longer appears in the list.
Screen
Note: By default, dynamic screen rotation (i.e., the ability to switch between landscape and portrait orientation) is disabled on
Dolphin 7900 terminals.
The Screen system setting contains three tabs: Alignment, Clear Type, and Text Size.
6 - 12 Rev F Dolphin® 7900 User's Guide
10/16/07